+8613017698506

How to deal with common faults of liquid filling machine

Dec 21, 2022

1. Bubbles and drips

If your liquid filling machine is experiencing foaming or dripping problems, the likely problem is an inadequate seal. Drips and foaming can waste liquid and cause significant cost in product loss over time, but this can be fixed by simply tightening the seal and making sure the valve does not leak when or after the filling process is complete. 


However, foaming issues may require the use of submersible nozzles. The submersible nozzle in the foam liquid filling machine application reaches the bottom of the container during the filling process, which actually solves the problem of foaming.

6-head-liquid-bottle-filling-machine38371862049

2. Inaccurate fill levels and timing

Another potential issue that can lead to product waste and an overall inadequate liquid filling line is inaccurate filling and timing. Incorrect fills can result in product spillage and wastage, or under filled containers can result in excess product.


A common cause of inaccurate fill levels is poor sealing. Check for wear on the seal, if tightening doesn't work, the seal may need to be replaced. Gaskets can also be a source of fill level problems, as well as low or high air pressure air hoses. Routine maintenance inspections of hose barbs and other parts that may have loosened or allowed air into the product passageway can help you avoid this. 


Some machines may include a touch screen that allows filling adjustments based on product volume. Time inaccuracy is a problem that is usually solved by changing operating settings rather than by adjusting the device hardware. Keep in mind the viscosity of the product, as this will also affect volume fill settings.


3. Power problem

Unlike previous issues, the lack of power has nothing to do with the device itself. To troubleshoot power issues, you should take steps to ensure that you avoid power surges and provide enough voltage to circulate evenly between your machines.


A power surge can have a very dramatic effect on your production line, potentially causing a complete breakdown, resulting in a complete loss of productivity, or if it lasts long enough, it can cause product damage.


Make sure your facility has a backup generator and enough power to handle every piece of equipment you bring in your liquid filling line. This will help ensure your equipment operates at optimum efficiency and avoid potentially costly failures.


Other Troubleshooting Methods

Machine won't start:

1. Turn on the power, turn on the power switch, and check the fuse.

2. Release the emergency stop button.

3. Turn on the air pressure and keep it at about 6 kg.

4. Check whether the switching power supply has DC24V power output.

5. Check whether the communication line between touch screen and PLC is loose.


No cutting:

1. Check the air pressure, check the touch screen maintenance mode screen.

2. Whether the nozzle is closed or not, check the circuit.

3. Feeding.

4. Check the air pressure, check whether the injection cylinder and the cylinder are dead together, check whether the feeding nozzle is closed on the maintenance mode screen of the touch screen, and check the circuit.


The filling dose is not allowed:

1. Check the feeding system.

2. Filter the material and clean the pipeline.

3. Replace the sealing ring of the pneumatic valve, air leakage in the trachea, and replace the pneumatic valve.

4. Clean the solenoid valve and replace the solenoid valve.

5. Clean the muffler gas and replace the muffler gas.

6. Adjust the ball valve to reduce the impact force and increase the diving depth.

7. Replace the O-ring.

8. Adjust the magnetic switch of the injection cylinder.


Leakage:

1. Tighten the feeding nozzle and replace the sealing gasket of the feeding nozzle.

2. Replace the feeding tube.

3. Clean the pneumatic valve and replace the gasket of the pneumatic valve.

4. Replace the sealing ring of the injection cylinder.


Send Inquiry