How to maintain the powder packaging machine?
The advanced automation mode not only effectively improves the production efficiency of enterprises, but also better guarantees the quality of product packaging. However, there are often many companies that do not understand the importance and maintenance methods of machine maintenance. The powder packaging machine must pay attention to daily maintenance and maintenance, because this will not only extend the service life of the equipment, but also the equipment itself will not malfunction and so on. For the maintenance of the powder packaging machine, here are a few suggestions for everyone:
1. Add oil lubrication: It is necessary to regularly add oil to the gear meshes, the oil hole of the seated bearing and the moving parts. It is strictly forbidden to run the reducer without oil once every shift. When adding lubricating oil, be careful not to put the oil tank on the rotating belt to prevent slipping and loss of rotation or premature aging of the belt and damage.
Another point that must be noted is that the reducer must not be operated when it is out of oil, and after the first 300 hours of operation, clean the interior and replace it with new oil, and then change the oil every 2500 hours of operation. When adding lubricating oil, do not drop the oil on the transmission belt, because this will cause the powder packaging machine to slip and lose rotation or the belt will be prematurely aging and damaged.
2. Frequent cleaning: Clean the metering part in time after the machine is stopped, and the heat-sealing device body must be cleaned frequently, especially for the packed materials with high sugar content in granules, cleaning the turntable and the unloading door, and the heat-sealing device body has also required The parts that are frequently cleaned to ensure that the sealing lines of the packaged product are clear. The scattered materials should be cleaned up in time to facilitate the cleanliness of the parts, so as to better extend their service life. At the same time, the dust in the electric control box should be cleaned frequently. To prevent electrical failures such as short circuits or poor contact.
3. Machine Maintenance: Maintaining the powder packaging machine is the key to prolonging the life of the packaging machine. Therefore, it is necessary to check the screws of each part of the powder packaging machine frequently, and there should be no looseness, otherwise, it will affect the normal long-distance rotation of the whole machine. The electrical parts should be waterproof, moisture-proof, anti-corrosion, and rat-proof to ensure that the inside of the electric control box and the wiring terminals are clean to prevent electrical failure. After the shutdown, the two heat sealers should be in an open position to prevent The packaging material is scalded.
The powder packaging machine occupies a very important position in the production and operation of the enterprise. Once the machine fails, the production period will be delayed. Therefore, the maintenance of the machine is very important and hopes to attract the attention of all enterprises.
